Antpact Toolbox
中文
Home › Modbus Tools › Modbus Address Converter

Modbus Address Converter

Convert between references (40001 etc.) and PDU offsets across all four zones.

Privacy: this tool runs entirely in your browser — files are never uploaded, and data is gone when you close the page.

How to use

  1. Type a reference (e.g. 40001) to see its type and offset instantly.
  2. Read the PDU offset and hex form — that is what actually goes in the frame.
  3. Compare the same offset across the other zones below.
  4. Switch to Offset → Reference to look up 5-digit and 6-digit forms.

FAQ

Why does 40001 map to offset 0?

Because references count from 1 while the protocol offset counts from 0 — they differ by one.

What are the four zones?

0x coils (read/write), 1x discrete inputs (read-only), 3x input registers (read-only) and 4x holding registers (read/write).

What is a 6-digit reference?

An extended form where 400001 means holding register offset 0, used by devices with addresses beyond 9999.

About this Modbus Address Converter

Modbus reference numbers (like 40001) count from 1, while the offset carried in the protocol starts at 0 — so 40001 maps to offset 0. That off-by-one is the most common field error. The four zones are 0x coils, 1x discrete inputs, 3x input registers and 4x holding registers. This tool converts both ways and handles 5-digit (40001) and 6-digit (400001) numbering.